Axis PTZ - Core Configuration Settings; Minimum Required Configuration Steps; Optional System and Image Configuration

Configuration AXIS Panorama PTZ User’s Manual
12
Configuration
Having installed your AXIS Panorama PTZ and confirmed that it is accessible on the
network, it is now ready for further configuration. Please note that both
cameras must be
installed and configured.
This section provides information on the minimum configuration necessary for the AXIS
Panorama PTZ, help on configuring the Panorama application, as well as a general
overview of the Web-based Administration Tools.
Minimum Configuration
The minimum configuration required for the AXIS Panorama PTZ should contain the
following points:
• Configured TCP/IP network settings, allowing the product to communicate on the network
• The password for the default user Admin should be changed, to enable the security
function
• Users should be defined and added, thus providing these with access to the camera
Although not required, you may also wish to configure the following:
• The system date and time.
• Images settings for resolution, brightness, compression, etc. Note that to maintain balance
in the Panorama application, these image settings should be made in each camera.
All of these settings can be configured and/or modified at any time from the
Administration Tools. Please see the product’s Online Help for more information.
Important!
• To access the Administration Tools, the product must first be installed on the network, as described
in Network Installation, on page 10.
• Javascript must be enabled in your Web browser for the AXIS Panorama PTZ Web-based interface to
work.