AXIS Q1602 Network Camera
System Options
Note
This FTP server has nothing to do with the product’s ability to transfer images via FTP to other locations and servers.
RTSP
The RTSP server running in the Axis product allows a connecting client to start an H.264 stream. The RTSP port number can be
changed under System Options > Network > TCP/IP > Advanced. The default port is 554.
Note
H.264 vide o streams will not be available if the RTSP server is disable d.
SOCKS
SOCKS is a netwo rking proxy protocol. The Axis product can be configured to use a SOCKS server to reach networks on the other
side of a firewall or proxy server. This functionality is useful if the Axis product is located on a local network behind a firewall, and
notifications, uploads, alarms, etc need to be send to a destination outside the local network (for example the Internet).
SOCKS is configured under System Options > N etwork > SOCKS . For more information, see the online help
.
QoS (Quality of Service)
QoS (Quality of Service) guarantees a certain level of a specified resource to selected traffic on a network. A QoS-aware network
prioritizes network traffic a nd provides a greater netwo rk reliability by controlling the am ount of bandwidth an application may use.
The Q oS settings are configured under System O ptions > Network > QoS. Using DSCP (Differentiated Services Codepoint) values, the
Axis product can mark the following types of traffic: live video, live audio, event/alarm traffic and management traffic.
Note
Live audio DSCP w ill be equal to live video DSCP if H.264 ove r RTSP is used.
SMTP (email)
To send email m essages from the Axis product via SMTP (Simple Mai l Transfer Protocol), an SMTP mail server must be set up. This
is do ne under System Options > Network > SMTP (email).
Enter the host names or IP addresses and port numbers for the primary and secondary mail servers in the fields pro vided . A From
email address is also required. If the mail server requires a
uthentication, check Use authentication to log in to this server and enter
the necessary information.
SNMP
The Simple Network Management P rotocol (SNMP) allows remote manag ement of network devices. An SNMP community is the
group of d evices and management stati
on running SNMP. Com munity names are used to identify groups.
The Axis product can be configured
to support SNMP on the System Options > Network > SNMP page.
Depending on the level of sec
urity required, select the version on SNMP to use.
SNMP v1/v2 provides the
lowest level of security. The community name can be specified as a password for re ad or read/write
access to all s upported SNMP devices. The default password for the Read community is public and the default password for the
Write community is wr ite.
Note
If HTTPS is enabled, SNMP v1 and SNMP v2c should be disabled.
Traps for SNMP v1/v2 are use d by the A xis product to send messages to a mana gement system on im porta nt events and status
change
s. Check Enable traps and enter the IP address where the trap message should be sent and the Trap community that
should receive the message.
40
To Next Page
Loading...
Need help?
General
