EasyManuals Logo

Axis Q1602 User Manual

Axis Q1602
55 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #41 background imageLoading...
Page #41 background image
AXIS Q1602 Network Camera
System Options
The following traps are a vaila ble :
•Coldstart
•Warmstart
•Linkup
Authentication failed
SNMP v3 provides encryption and secure passwords. To use traps with SNMP v3, an SNMP v3 management application is required.
To use SNM P v3, HTTPS must be enabled, see
HTTPS, on page 35
. To enable SNMP v3, check the box and provide the initial user
password.
Note
The initial password can only be set once. If the password is lost, the Axis product must be reset to factory default, see
Reset to Factory Default Settings, on page 45
.
UPnP
TM
The Axis product includes support for UPnP
TM
.UPnP
TM
is enabled by default and the p roduct is automatically detected by operating
systems and clients that support this protocol.
UPnP
TM
can b e disabled under System Options > Network > UPnP
TM
.
RTP/H.264
The RTP port range and multicast settings are co ng u red under System Options > Network > RTP.
The RTP port range denes the range of ports from which the video/audio ports are auto
matically selected. For multicast streams,
only certain IP addresses and port numbers should be used.
Select Always M ulticast Video and/or Always Multicast Audio to start multicast streami n g w itho u t open in g an RTSP session.
Bonjour
The Axis product includes support for Bonjour. Bonjour is enabled by default and the product is automatically detected by op erating
systems and clients that support this protoc
ol.
Bonjour can be disabled under System O p
tions > Network > Bonjour.
Storage
SD Card
NOTICE
To prevent corruption of recordings, the SD card should always be unmounted before it is ejected.
The Axis product supports SD cards with the following le systems:
ext4 re com m e nde d due to its resi lie nce against data loss if the card is ejected or if there is abrupt power loss. To access
data stored on the card from the W indow s opera ting system, a third- party ext4 driver or application is required.
vFAT most SD cards are pre-formatted with vFAT when purchased.
If required, the SD card can be re-formatted to the desired le system . To format the S D card:
1. Insert the SD card in the SD card slot.
2. Go to System Options > Storage an d click SD Card.
41

Other manuals for Axis Q1602

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the Axis Q1602 and is the answer not in the manual?

Axis Q1602 Specifications

General IconGeneral
BrandAxis
ModelQ1602
CategorySecurity Camera
LanguageEnglish

Related product manuals