AXIS Q1602 Network Camera
System Options
Port Status
The list on the System Options > Ports & Devices > Port Status page shows the status of the product’s input and output ports.
Maintenance
The Axis product provides several maintenance functions. These are available under System Options > Maintenance.
Click Restart to perform a correct restart if the Axis prod uct is not behaving as expected. This will not affect any of the current
settings.
Click Restore to reset most settings to the factory defa ult values. The fo llowing settings are not affected:
• the boot pro tocol (DHCP or static)
• the static IP address
• the default router
• the subnet m ask
•thesystemtime
• the IEEE 802.1X settings
• the focus position
Click Default to reset all settings, includ ing the IP address, to the factory default values. This button should be used w
ith caution. The
Axis product can also be reset to factory default using the control button, see
Reset to Factory Default Setting s, on page 45
.
To identify the product or test the Status LED, click Flash LED under Identify and specify the duration in seconds, minutes or hours.
This can be u seful for identifying the product am ong other products installe d in the same location.
For information about firmwar e upgrade, see
Upgrading the Firmware, on pag e 46
.
Support
Support Overview
The System Options > Support > Support Overview page provides information on troubleshooting and contact information,
should you require technical assistance.
See also
Troubleshooting, on page 46
.
43
To Next Page
Loading...
Need help?
General
