Axis Q8752-E Mk II - Set up Washer

18
2. Connect the Axis portcast device (2) and the PoE switch (3) with a PoE cable.
1 Axis network video device
2 Axis portcast device
3 Switch
Once the devices are connected, an audio tab becomes visible in the settings for your Axis network video device.
Go to the audio tab and turn on Allow audio.
See your Axis portcast device’s user manual for more information.
Set up washer
Note
The washer is optional.
1. Go to System > Accessories > I/O Ports.
2. For the port used with the washer — set Output as the direction.
3. Go to the live view and use the joystick (or mouse) to position the washer nozzle in the center of the
image.
4. Go to System > Accessories > Washer.
5. Turn on Lock nozzle position.
6. Under Pump connection, select the pin (I/O port) the washer is connected to.
7. To set the duration of the washer sequence in seconds, enter a value under Pump time. The wiper starts
when there is 5 seconds left of this time.
8. To set the duration of the wiper sequence in seconds, enter a value under Wiper time.
The below table provides some examples of different washer-wiper sequence setups.
Time elapsed (seconds) Washer pump time: 10 s
Washer wiper time: 10 s
Washer pump time: 20 s
Washer wiper time: 12 s
0 Washer starts Washer starts
5 Wiper starts —
10 Washer stops —
15 Wiper stops Wiper starts
20 — Washer stops
22 — Wiper stops
AXIS Q8752-E Mk II Bispectral PTZ Network Camera