Axis Q8752-E Mk II - Network

45
Synchronization: Select an option for the device’s date and time synchronization.
• Automatic date and time (manual NTS KE servers): Synchronize with the secure NTP key
establishment servers connected to the DHCP server.
– Manual NTS KE servers: Enter the IP address of one or two NTP servers. When you use two NTP
servers, the device synchronizes and adapts its time based on input from both.
– Max NTP poll time: Select the maximum amount of time the device should wait before it polls the
NTP server to get an updated time.
– Min NTP poll time: Select the minimum amount of time the device should wait before it polls the
NTP server to get an updated time.
• Automatic date and time (NTP servers using DHCP): Synchronize with the NTP servers connected to
the DHCP server.
– Fallback NTP servers: Enter the IP address of one or two fallback servers.
– Max NTP poll time: Select the maximum amount of time the device should wait before it polls the
NTP server to get an updated time.
– Min NTP poll time: Select the minimum amount of time the device should wait before it polls the
NTP server to get an updated time.
• Automatic date and time (manual NTP servers): Synchronize with NTP servers of your choice.
– Manual NTP servers: Enter the IP address of one or two NTP servers. When you use two NTP servers,
the device synchronizes and adapts its time based on input from both.
– Max NTP poll time: Select the maximum amount of time the device should wait before it polls the
NTP server to get an updated time.
– Min NTP poll time: Select the minimum amount of time the device should wait before it polls the
NTP server to get an updated time.
• Custom date and time: Manually set the date and time. Click Get from system to fetch the date and
time settings once from your computer or mobile device.
Time zone: Select which time zone to use. Time will automatically adjust to daylight saving time and standard
time.
• DHCP: Adopts the time zone of the DHCP server. The device must connected to a DHCP server before
you can select this option.
• Manual: Select a time zone from the drop-down list.
Note
The system uses the date and time settings in all recordings, logs, and system settings.
Device location
Enter where the device is located. Your video management system can use this information to place the device
on a map.
• Format: Select the format to use when you enter your device's latitude and longitude.
• Latitude: Positive values are north of the equator.
• Longitude: Positive values are east of the prime meridian.
• Heading: Enter the compass direction that the device is facing. 0 is due north.
• Label: Enter a descriptive name for your device.
• Save: Click to save your device location.
Network
IPv4
AXIS Q8752-E Mk II Bispectral PTZ Network Camera