Axis Q8752-E Mk II - Buttons; Control Button; Connectors; Network Connector

82
2. Loosen the four top cover screws and remove the top cover.
3. Insert the SD card. To find out where the SD card slot is placed, see .
4. Put back the top cover and tighten the screws (torque 2.0 Nm).
5. Reconnect power to the device.
Buttons
Control button
The control button is used for:
• Enabling the Focus Assistant. Press and very quickly release the Control button.
• Calibrating the speaker test. Press and release the control button and a test tone is played.
• Resetting the product to factory default settings. See .
• Ensuring the camera is level. Press the button for not more than two seconds to start the leveling
assistant and press again to stop. The status LED and buzzer signal (see ) assist leveling of the camera.
The camera is level when the buzzer beeps continuously.
• Ensuring the camera is level. Press the button for not more than two seconds to start the leveling
assistant and press again to stop. The buzzer signal (see ) assist leveling of the camera. The camera is
level when the buzzer beeps continuously.
• Resetting the product to factory default settings. See or
• Connecting to an AXIS Video Hosting System service. To connect, press and hold the button for about
3 seconds until the status LED flashes green.
• Connecting to a one-click cloud connection (O3C) service over the internet. To connect, press and hold
the button for about 3 seconds until the status LED flashes green.
Connectors
Network connector
The Axis device is available in two variants with different network connectors:
RJ45 Ethernet connector.
RJ45 Ethernet connector with Power over Ethernet (PoE).
RJ45 Ethernet connector with Power over Ethernet Plus (PoE+).
RJ45 with High Power over Ethernet (High PoE).
AXIS Q8752-E Mk II Bispectral PTZ Network Camera