83
RJ45 Push-pull Connector (IP66) with High Power over Ethernet (High PoE).
RJ45 Ethernet service port.
D-coded M12 connector with Power over Ethernet (PoE).
SFP connector.
Input: RJ45 Ethernet connector with Power over Ethernet (PoE).
Output: RJ45 Ethernet connector with Power over Ethernet (PoE).
NOTICE
To comply with the IP66-rated design of the camera and maintain the IP66 protection, the supplied RJ45
Push-pull Connector (IP66) shall be used. Alternatively, use the RJ45 IP66-rated cable with premounted
connector which is available from your Axis reseller. Don’t remove the plastic network connector shield from
the camera.
NOTICE
The device shall be connected using a shielded network cable (STP). All cables connecting the device to the
network shall be intended for their specific use. Make sure that the network devices are installed in
accordance with the manufacturer’s instructions. For information about regulatory requirements, see the
Installation Guide at www.axis.com.
Audio connector
3.5 mm connector
• Audio in – 3.5 mm input for a mono microphone, or a line-in mono signal (left channel is used from a
stereo signal).
• Audio in – 3.5 mm input for a digital microphone, an analog mono microphone, or a line-in mono signal
(left channel is used from a stereo signal).
• Audio in – 3.5 mm input for two mono microphones, or two line-in mono signals (using the supplied
stereo-to-mono adapter).
• Audio in – 3.5 mm input for a stereo microphone, or a line-in stereo signal.
• Audio out – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system
or an active speaker with a built-in amplifier. A stereo connector must be used for audio out.
• Audio out – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system
or an active speaker with balanced input and a built-in amplifier. A balanced connector must be used
for audio out.
• Audio out – 3.5 mm output for audio (line level) that can be connected to a public address (PA) system
or an active speaker with a built-in amplifier. A pair of headphones can also be attached. A stereo
connector must be used for audio out.
Audio input
1 Tip 2 Ring 3 Sleeve
Unbalanced microphone (with or without
electret power) or line-in
Electret power if selected Ground
Balanced microphone (with or without
phantom power) or line-in, “hot” signal
Balanced microphone (with or without
phantom power) or line-in, “cold” signal
Ground
Digital signal Ring power if selected Ground
Stereo unbalanced microphone (with or
without electret power) or line-in, “left”
Stereo unbalanced microphone (with or
without electret power) or line-in, “right”
Ground
AXIS Q8752-E Mk II Bispectral PTZ Network Camera
To Next Page
Loading...
