21
Click to play the live video stream.
Click to freeze the live video stream.
Click to take a snapshot of the live video stream. The file is saved in the ‘Downloads’ folder on your
computer. The image file name is [snapshot_YYYY_MM_DD_HH_MM_SS. jpg]. The size of the snapshot
depends on the compression that the specific web-browser engine where the snapshot is received applies,
therefore, the snapshot size may vary from the actual compression setting that is configured in the device.
Click to show I/O output ports. Use the switch to open or close the circuit of a port, for example, to
test external devices.
Click to manually turn on or turn off the IR illumination.
Click to manually turn on or turn off the white light.
Click to access onscreen controls:
• Predefined controls: Turn on to use the available onscreen controls.
• Custom controls: Click Add custom control to add an onscreen control.
Starts the washer. When the sequence starts, the camera moves to the configured position to
receive the wash spray. When the whole wash sequence is completed, the camera returns to its previous
position. This icon is only visible when the washer is connected and configured.
Starts the wiper.
Click and select a preset position to go to that preset position in the live view. Or, click Setup to
go to the preset position page.
Adds or removes a focus recall area. When you add a focus recall area, the camera saves the
focus settings at that specific pan/tilt range. When you have set a focus recall area and the camera enters
that area in the live view, the camera recalls the previously saved focus. It’s enough to cover half of the area
for the camera to recall the focus.
Click to select a guard tour, then click Start to play the guard tour. Or, click Setup to go to the
guard tours page.
Click to manually turn on the heater for a selected period of time.
Click to start a continuous recording of the live video stream. Click again to stop the recording. If a
recording is ongoing, it will resume automatically after a reboot.
Click to show the storage that is configured for the device. To configure the storage, you need to be
logged in as an administrator.
Click to access more settings:
• Video format: Select the encoding format to use in the live view.
AXIS Q8752-E Mk II Bispectral PTZ Network Camera
To Next Page
Loading...
