Azbil C15 User Manual

2-3
Chapter 2. OUTLINE OF FUNCTIONS

Data setting procedures
(1) Operate the [para] key to display desired data to be set.
(How to operate the [para] key is described in the previous section, "Flow of
general key operation".)
mode
pv
sp
mode
pv
sp
(This Figure shows the display when
setting the PV range type of the setup
setting [
C0 1].)
(This Figure shows the display when
setting the RUN/Ready selection in
the parameter setting [r...r].)
(2) Press any of the [<], [
<
], and [
<
] keys.
>> When the display No. 2 shows a numeric value, the 1st digit starts flashing.
Additionally, when the display No. 2 shows a character string, the entire
character string starts flashing.
When a numeric value is displayed, the value can be increased or decreased
or the flashing digit can be moved using the [<], [
<
], or [
<
] key.
When a character string is displayed, the entire flashing character string can
be changed using the [
<
] or [
<
] key.
mode
pv
sp
mode
pv
sp
(This Figure shows the display when
the 1st digit of "
000 1" is ashing.)
(This Figure shows the display when
the entire character string "rUn" is
ashing.)
(3) Release the key and wait for a while.
>> After 2 s have elapsed, the flashing display is stopped, and then the data you
have changed is set.
mode
pv
sp
mode
pv
sp
Handling Precautions
• If the data does not start flashing even though the [<], [
<
], or [
<
] key is
pressed, this data cannot be changed.

Azbil C15 Specifications

General

Brand	Azbil
Model	C15
Category	Controller
Language	English