LOWER THREADING
18
■ Using the Spool Pin
You can use the main spool pin to wind the bobbin
before embroidering. You cannot use this spool pin
to wind the bobbin while embroidering.
a
Turn the main power to ON and open the
top cover.
b
Align the groove in the bobbin with the
spring on the bobbin winder shaft, and set
the bobbin on the shaft.
a Groove in the bobbin
b Spring on the shaft
c
Pivot the spool pin so that it angles upward.
Set the thread spool on the spool pin so that
the thread unwinds from the front of the
spool.
a Spool pin
b Spool cap
c Thread spool
d Spool felt
d
Push the spool cap onto the spool pin as far
as possible, then return the spool pin to its
original position.
e
While holding the thread with both hands,
pull the thread up from under the thread
guide plate.
a Thread guide plate
f
Pass the thread through the thread guide.
a Thread guide
g
Pass the thread around the pretension disk
making sure that the thread is under the
pretension disk.
a Thread guide
b Pretension disk
h
Follow steps g through k on page 16
through 17.
a
b
a
a
b
To Next Page
Loading...
