Baby Lock Solaris VISION BLSA3 - Checking the Needle Drop Point with the Projector; Aligning the Embroidering Position Using the Built-In Camera

CONFIRMING THE PATTERN POSITION
43
Embroidery Step by Step
1
Checking the Needle Drop Point
With the Projector
With the projector pointer, you can check the
needle drop point before embroidering.
a
Touch in the embroidery screen.
 The pointer of the projector indicates the needle
drop point onto the fabric.
Aligning the Embroidering
Position Using the Built-In
Camera
The camera built into this machine can be used to
easily align the embroidering position. This is
useful for patterns which need to be embroidered
in a particular position as shown below.
a
Use a chalk pencil to draw a cross at the
desired embroidering location.
a Chalk pencil mark
b
Hoop the fabric.
c
Select the pattern on your machine and
touch .
Memo
• The color and shape of the pointer can be
changed in the settings screen.
• When the pointer of the projector is turned on,
the embroidery foot height is automatically
adjusted according to the fabric thickness.
• If embroidery foot “W+” with LED pointer (sold
separately) is installed, the LED pointer is
turned on.
• The pointer of the projector turns off
automatically by lowering the embroidery foot
or returning to the previous page.
Note
• With fabric that has a very uneven surface
such as thick fabric or quilting, the fabric
thickness may not be correctly measured. In
this case, the pointer indication should be
used only as a reference.