Baby Lock Solaris VISION BLSA3 - Aligning the Pattern and the Needle

MAKING EMBROIDERY ADJUSTMENTS
96
Using the Thread Trimming
Function (Jump Stitch Trim)
The thread trimming function will
automatically trim any excess thread jumps within
the color. This function is initially turned ON. To
turn this function OFF, touch key and then
.
* Your customized setting remains after turning the
machine off and on.
a Jump stitch
a
Touch .
b
Touch to turn off the thread trimming
function.
 The key will display as . The machine will
not trim the thread before moving to the next
stitching.
■ Selecting the Trim Function to Adjust
Jump Stitch Length
When the thread trimming function is turned
on, you can select the length of the jump stitch.
Stitches below the value will not be trimmed.
* Your customized setting remains after turning the
machine off and on.
Touch or to select the length of jump
stitch.
For example: Touch to select 25 mm (1 inch)
and the machine will not trim a jump stitch of 25
mm or less before moving to the next stitching.
Memo
• If design has many trims, it is recommended
to select a higher jump stitch trim setting in
order to reduce the amount of excess tails on
backside of fabric.
• The higher number of the jump stitch length
selected, the fewer number of times the
machine will trim. In this case, more jump
stitches remain on the surface of the fabric.