1.21 Appendix C. Tested ARM platforms 225
The power (by default 10W) via the micro-USB connector is not sufficient if peripherals (e.g. keyboard, mouse,
cameras, etc...) are connected. To avoid the system from throttling due to over-current, please supply the board
with power through the Barrel Jack connector (4A@5V), when powering the USB/USB3 camera through the USB
bus.
1.21.1.4 NVIDIA Jetson TX2
CPU ARM Cortex-A57 @ 2GHz
NVIDIA Denver2 @ 2GHz
Cores 4
2
RAM 8GB
USB2.0 Interfaces 1
USB3.0 Interfaces 1
Ethernet 10/100/1000 MBit
PCIe 1x4 + 1x1 | 2x1 + 1x2
Gen 2.0
1.21.1.4.1 General
Note
The above table describes the specification of the NVIDIA Jetson TX2 Developer Kit.
1.21.1.4.2 Test Setup
Test setup
MATRIX VISION GmbH
To Next Page
Loading...
