96 ImagePRO-II • User’s Guide
4. Menu Orientation
Restoring Factory Default Settings
• The Customer Support telephone number. This number is accessible from 6 a.m.
to 10 p.m. (PST), 7 days per week.
• The Customer Support web site address.
oÉëíçêáåÖ=c~Åíçêó=aÉÑ~ìäí=pÉííáåÖë
Two options in the Setup Menu allow you to restore the ImagePRO-II to its factory default
condition. The following attributes constitute a factory default condition:
• The Status Menu is shown in the display screen.
• Input 1 is powered on.
• All other menu buttons and effects buttons are off.
• The Area of Interest is the default active area for each output.
• There is no logo stored in memory. If you saved a logo, the logo is deleted.
• All custom configurations, views, and formats are deleted.
The Factory Reset Menu provides two options for restoring factory default settings:
• Factory Reset — If you use this option, all of your custom input, output, and
system configuration files are deleted. All custom views and formats are deleted.
If you have a stored logo, it is deleted.
• Factory Reset, Save IP — This option performs a factory reset, but retains the IP
address of the ImagePRO-II.
oÉëíçêáåÖ=^ää=c~Åíçêó=pÉííáåÖë
To restore all default settings to the ImagePRO-II, use the following procedure:
1. Select Factory Reset from the Setup Menu. The Factory Reset Menu appears.
2. Select Factory Reset. A prompt appears, asking if you want to clear all
configurations, formats, and views.
3. Press SEL. The system turns off, then reboots.
If you press ESC to cancel the operation instead, your custom settings remain in
place and you are returned to the Factory Reset Menu.
oÉí~áåáåÖ=íÜÉ=fm=^ÇÇêÉëë=tÜÉå=oÉëíçêáåÖ=c~Åíçêó=
pÉííáåÖë
To restore default settings to the ImagePRO-II but retain the unit’s IP address, use the
following procedure:
1. Select Factory Reset from the Setup Menu. The Factory Reset Menu appears.
2. Select Factory Reset, Save IP. A prompt appears, asking if you want to clear all
configurations, formats, and views.
Note
It is advisable to clear all saved configurations when you use
the ImagePRO-II for the first time, or when returning an
ImagePRO-II from an event.
To Next Page
Loading...
