To Next Page

To Previous Page

ImagePRO-II • User’s Guide 159

B. Remote Control Protocol

Legacy Remote Commands

--itype (input type): 0 = digital, 1 = analog

--new (new format name): Use " " around the format name. Use

VFSTDLIST to get the standard format names. This command option

changes the format to “new format name.”

--enum (new format enum): Use VFSTDLIST to get the standard format

names.

--reset (reset default timing)

--name (format name): This command option simply renames the current

format.

--hsync (horizontal sync)

--hact (horizontal active)

--hfp (horizontal front porch)

--hpos (horizontal position)

--htot (horizontal total)

--vsync (vertical sync)

--vact (vertical active)

--vfp (vertical front porch)

--vpos (vertical position)

--vtot (vertical total)

• Query Format:

VFS --?

• Query Response: Video Format settings in the following format:

VFS --name "format name" --hsync (hsync) --hact (hact)

--hfp (hfp) --htot (htot) --vsync (vsync)

--vact (vact) --vfp (vfp) --vtot (vtot)

iÉÖ~Åó=oÉãçíÉ=`çãã~åÇë

The following commands have been carried over from the original ImagePRO.

^`n=ãçÇÉ

• Description: Turns input Auto acquisition mode off/on.

• Parameters: mode [0 | 1]: Off | On

• Query Format:

ACQ?

Returns Auto acquisition mode in the format

= mode

 ACQ 0 (Turns auto acquisition mode off)

 ACQ? (Queries for auto acquisition mode)

Barco ImagePRO-II User Manual

Other manuals for Barco ImagePRO-II