Barco ImagePRO-II - Selecting a Firmware File to Upload with the Web Interface

170 ImagePRO-II • User’s Guide
`K==réÖê~ÇáåÖ=cáêãï~êÉ
Upgrading Firmware Using the Web Interface
4. Scroll to the file you want to use, and press SEL.
5. Scroll to Upgrade and press SEL again.
A progress message appears.
When the file is loaded, the ImagePRO-II powers down and reboots.
réÖê~ÇáåÖ=cáêãï~êÉ=rëáåÖ=íÜÉ=tÉÄ=fåíÉêÑ~ÅÉ=
Before you begin the firmware upgrade, ensure that your PC, laptop, or mobile device uses
one of the following operating systems:
• Windows
®
XP, Windows
®
Vista™, or Windows
®
7
• Mac OS
®
X
• Red Hat
®
Linux
®
You must also know the IP address of your ImagePRO-II unit, which you can find by
selecting Setup > System > Ethernet.
`ÜÉÅâáåÖ=Ñçê=^î~áä~ÄäÉ=cáêãï~êÉ=réÖê~ÇÉë
 To determine whether a new version of the ImagePRO-II firmware is available, use the
following procedure:
1. Verify that the ImagePRO-II has internet access. Contact your system
administrator if necessary.
2. Select Setup > Firmware Upgrade > Web Upgrade. The submenu shown in the
following illustration appears.
Figure C-4. Web Firmware Upgrade Submenu
3. Select Check.
A message informs you if a new firmware version is available. To install the latest
version over the internet, refer to the following section, Automatically Upgrading
Firmware Using the Web Interface.
If you wish to install a different version, refer to the section of this chapter titled
Selecting a Firmware File to Upload with the Web Interface
on page 171.
If you are not connected to the internet, a message prompts you to check the
connection.
Note
Do not remove the flash drive or power down the
ImagePRO-II until the firmware file is uploaded.
WEB FIRMWARE UPGRADE
> Check >>
Verify internet access
before continuing.