ImagePRO-II • User’s Guide 43
4. Menu Orientation
Configuring Inputs
pÉííáåÖ=fåéìí=`çäçê=_~ä~åÅÉ
From the Input Menu, select Color Balance to change contrast, brightness, hue, and
saturation values for the selected input. The Input Color Balance Submenu appears. The
values for contrast, brightness, and saturation are in percentages. The values for hue are in
degrees.
Figure 4-13. Input Color Balance Submenu
• As with the global Contrast and Brightness menus, you can adjust both contrast
and brightness within a range of 25% to 150%. The default setting for both
contrast and brightness is 100%.
• Hue is measured in degrees. The range is -90 to +90 degrees. The default setting
is 0.
• Saturation is a percentage, ranging from 0% to 150%. The default setting is
100%.
• Reset All restores all settings to their default values.
^ÇàìëíáåÖ=d~ãã~=
From the Input Menu, select Gamma to set the input gamma to match the gamma of the
source. The adjustment range is from 1.0 to 3.0, in 0.1 increments. The default value is 1.0.
mêçÅÉëëáåÖ=fåíÉêä~ÅÉÇ=~åÇ=cáäã=páÖå~äë
The ImagePRO-II supports working with television and film signals in two ways:
• By providing the means to deinterlace a non-progressive signal for use on fixed-
resolution displays.
~ In interlaced video, even lines in a frame are scanned during one field
and odd lines are scanned during the next field. This scanning method
was used in analog television. Deinterlacing is the process of converting
the two interlaced fields in a frame to one progressive frame.
~ In progressive video, lines in the frame are scanned sequentially. This
is the scanning method used for modern digital displays.
• By providing the means to detect the 3:2 pulldown sequence for converting film to
video.
These capabilities are found on the Processing Submenu. From the Input Menu, select
INPUT COLOR BALANCE
> Red Contrast 100
Red Brightness 100
Green Contrast 100
Green Brightness 100
Blue Contrast 100
Blue Brightness 100
Hue +0
Saturation 100
Reset All
To Next Page
Loading...
