46 ImagePRO-II • User’s Guide
4. Menu Orientation
Configuring Inputs
4. Use the ADJUST knob to scroll to the first character you want to use for the
format name.
5. Press SEL. The cursor moves to the next character field, which is now blank with
an underscore.
6. Repeat the previous steps as many times as needed, pressing SEL for each
character selection.
A file name can consist of up to 19 alpha-numeric characters.
7. When you have selected all the characters, press SEL again to save the name. If
you have never used this file name before, the Config Saved message appears
on the menu, as shown in the following illustration.
Figure 4-16. Config Saved Message
If you have used this file name before, the ImagePRO-II displays the following
prompt.
Figure 4-17. Overwrite File Message
Note
Turning the ADJUST knob clockwise once moves to the next
letter of the alphabet. If you start with an upper-case letter,
as shown in the preceding illustration, then the next letter is
also a capital letter. If you start with a lower-case letter, the
next letter is a lower-case letter:
F --> G
f --> g
If you start with a number, the next character is a number.
Continuing to turn the ADJUST knob clockwise at the end of
the upper-case alphabet displays a series of punctuation
marks you can use in the format name.
Continuing to turn the knob clockwise at the end of the
punctuation marks displays the lower-case alphabet in order.
When you reach the end of the lower-case alphabet, turn the
ADJUST knob counter-clockwise to scroll back through the
options in order.
SAVE CONFIG AS
> MyFileName
Save Config
-- Config Saved --
Overwrite MyFileName?
<SEL> = Yes
<ESC> = No
To Next Page
Loading...
