Barco NGS-D320 Lite User Manual

4. Operation
A pop-up dialog will appear where one can set the administrator password.
Image 4-3
New password
Fill in the new administrator password, confirm and press Set password.
Login
After initial login, there are 2 access levels for the webUI:
• User
The webUI is read only, no changes can be made.
- User name: user
- The initial user password is <empty>
- A new user password can be set in the Administration section (refer to image 4-3 for explanation)
• Administrator
The webUI is fully accessible, all changes can be made.
- User name: admin
- The initial admin password was set an initial logon
- The admin password can be changed in the Adminstration section (refer to image 4-3 for explana-
tion)
Once logged in, the webUI of the device shows up.
Logout
Press the logout button to log out.
4.3 Discovery
4.3.1 Introduction
Discovery methods
Before you can operate your device(s), you must know its (their) location in the network. The location is
defined by the device’s IP address.
The IP address can be discovered using one of these methods:
K5903129 NGS-D320 29/09/2016
23

Barco NGS-D320 Lite Specifications

General

Brand	Barco
Model	NGS-D320 Lite
Category	Media Converter
Language	English