Barco NGS-D320 Lite User Manual

4. Operation
2. The Gain is by default set to 50%. Move the slider to adjust the gain.
3. The audio Encoding profile is by default set to “Uncompressed L-16”. No other profiles are available.
To disable the audio encoding: Select (disabled) in the encoding profile drop down list.
4. Define the destination/port in the Destination field:
- Multicast: enter the valid multicast address/port
- Unicast: leave the destination field empty
5. DefinetheTimetoLiveunderttl. This is by default set to 5.
6. The RTSP url can be copied from the rtsp link. Right click rtsp and save as. This url can be used to
connect an RTSP client to the NGS-D320.
7. Press Apply to save settings.
4.5.3.3 DVI In/DP In/HDMI In
Input EDID
1. By default, the Input EDID is set to “Default EDID”
Choose the desired Input EDID setting in the Input EDID drop down box. Select the default setting or
one of the specific timings.
Image 4-18
Encoder settings DVI In / DP In / HDMI In
On NGS-D320 Lite devices, only Stream 0 can be configured
On NGS-D320 Pro devices, Stream 0 & 1 can be configured independently.
2. The Encoding profile is by default set to “auto”. Select the desired Encoding profile.
To disable Encoding explicitly for an input: Select (disabled) in the encoding profile drop down list.
3. Define the destination/port in the Destination field.
- Multicast: valid multicast address/port
- Unicast: leave the destination field empty
4. DefinetheTimetoLiveunderttl. This is by default set to 5.
5. The RTSP url can be copied from the rtsp link. Right click rtsp and save as. This url can used to
connect an RTSP client to the NGS-D320.
36
K5903129 NGS-D320 29/09/2016

Barco NGS-D320 Lite Specifications

General

Brand	Barco
Model	NGS-D320 Lite
Category	Media Converter
Language	English