4. Operation
Image 4-5
OSD display output
4.3.4 Web Interface Discovery
WebUI procedure
To be able to discover other NGS-D320 devices from the web UI of one NGS-D320 device, you must first
logintothisdevice.
1. Login ("Login", page 22).
2. Select the tab Discovery
Image 4-6
Discov e ry
3. The system starts searching the network and lists all devices linked to your network.
4. The table lists this information for your NGS-D320:
- ID: Identification LED is lit or not (lightbulb)
- Name: Name of the device in the system
- Encoder: Audio/Video inputs
2
- Decoder: Audio/Video outputs
3
- IP address: Device IP address
More information on the device (software version, serial number,…) can be shown in the table by click-
ing
This table is read-only. It cannot be used for multiple device configuration accross the network. To
achieve that, the device must be used in Managed mode in a system.
5. Press the light bulb in the table above (image 4-6) : The corresponding device will be put in or out of
Identification mode.
A device in Identification mode will blink the blue identification LED and put an identification message
in overlay on all video outputs.
2. Blue when actively receiving signal (This doesn’t mean it is encoded, it means there is an active and correct signal present at this
interface.)
3. Blue: see above.
K5903129 NGS-D320 29/09/2016 25
To Next Page
Loading...
Need help?
General
