R5911443 /11 UDM166
• Via Barco Insights Management Suite when the GSM module is installed. For more information on how to
set up and use the Flex license, see Projector Management Suite user guide, chapter “Projector
Configuration tab” – “Flex brightness”
• Via the OSD menu of the projector itself
To lock to a specific value a 4 digit code is necessary. These codes can be created by the projector owner
using Projector Toolset or the Projector Management Suite.
Availability
The flex brightness function is license protected. This license is already available in the projector. To activate
the flex brightness a flex code is necessary. This flex code can be requested for free and uploaded via
Projector Toolset or the Projector Management Suite. For more information about uploading this flex code, see
Projector Toolset’s user guide, chapter ““FLEX, light output control””.
For other models, Flex brightness is an option. You can order and buy a license file. This license file is linked
with the projector type and projector serial number. Once you received you license file, upload this file via
Projector Toolset to your projector. Once the file is uploaded, the same file has to be used to upload the Flex
code.
Flex codes
Once your flex code is correctly uploaded, the projector creates a number of flex codes, one for each possible
maximum light output. These codes are used for rental activities when adapting the light output of the
projector.
The created flex codes are only visible in Projector Toolset and the Projector Management Suite by the
projector owner. To make these visible he will need his license for this typical projector.
Maximum Light output setup via OSD menu
1. In the main menu, select Settings → Maintenance → Flex → Brightness.
Image 10–63 Flex menu, Flex Brightness
The Flex Brightness menu is displayed.
Image 10–64 Example of the Flex license menu
2. Choose the desired Light output (in lumens) for which you have a code available.
3. Enter the code via the OSD menu and confirm.
GUI – System Settings
To Next Page
Loading...
