R5911443 /11 UDM88
8.1 Orientation
What can be done?
The way of physical installation of the projector can be defined to the projector.
The following installation are possible:
• Desktop front: Projected image will not be flipped or mirrored.
• Desktop rear: Projected image will be flipped horizontally (left side switches to the right side).
• Ceiling front: Projected image will be flipped vertically (top side switches to the bottom side).
• Ceiling rear: Projected image will be flipped both vertically and horizontally.
• Auto front: The tilt sensor will detect if the projector is desktop or ceiling mounted and will project a
readable image accordingly.
• Auto rear: The image will be flipped horizontally. The tilt sensor will detect if the projector is desktop or
ceiling mounted and will project a readable image accordingly.
How to set the correct orientation
1. In the main menu, select Installation → Position → Orientation.
Image 8–1 Installation menu, orientation
The Orientation menu is displayed.
Image 8–2 Example of the orientation menu
2. Use the ◄ or ► keys to select the projector orientation mode and press OK to activate.
8.2 Laser ranging
What can be done?
When the optional laser range finder is installed on the projector, you can use the laser source to measure the
distance between the front of the projector and the surface you are projecting on. This can help you fine-tune
the position of the projector.
From Pulse 2.3.8 onward you can now also store the measured distance as a reference value and verify the
distance at certain time intervals (e.g. during startup). This way, you will be notified if the projector has been
moved from its original reference position.
GUI – Installation
To Next Page
Loading...
