39R5911443 /11 UDM
Tip: A few examples:
To enter address 3, press "3" digit button on the RCU to set the RCU's address to 3 and wait until
the button pressed indicator is out. Alternatively, you can also press “0” and “3”. This way, the
button pressed indicator goes out immediately.
To enter address 31, then press “3” and “1” on the digit button on the RCU and the button pressed
indicator goes out immediately.
3.10 Using the XLR connector of the RCU
Connecting a cable with the XLR connector will reset the broadcast address of the RCU to its default
value '0'.
Revised RCU
Revised Remote Control Units produced from April 2023 onward will require the projector to run software 2.3.x
(or newer) in order to properly use the XLR connector. If not yet updated to the most recent version, update
the projector software. For more information, see “Software update”, page 194.
How to use the XLR connector
1. Remove the XLR cover by pulling it backwards.
Image 3–8
2. Connect a cable with XLR plug into the XLR connector of the RCU.
3. Connect the other end of the cable with the XLR input of the projector.
Note: While the XLR cable is connected, the IR beam of the RCU is switched off.
3.11 Using the mini-jack connector of the RCU
Connecting a cable with the mini-jack connector will reset the broadcast address of the RCU to its
default value '0'.
How to use the mini-jack connector
1. Connect a cable with the mini-jack connector (reference 2 Image 3–9) of the RCU.
2. Connect the other end of the cable with the mini-jack input of the projector.
Pulse Remote Control Unit
To Next Page
Loading...
