Barco UDM - 3.7 Pulse RCU, function of the “RGB filter” button; 3.8 Pulse RCU, functions of the “Projector OSD on;off” button; 3.9 Displaying and Programming addresses into the RCU

R5911443 /11 UDM38
• Slowly flashes (2 times a second) when the battery level is becoming low; typically when more than 85% of
the useful life is past.
3.7 Pulse RCU, function of the “RGB filter” button
Filtering the color of the projected image
By pressing the RGB filter button on the RCU you can place a color filter on the output of the projector. This
feature can be useful during the installation and configuration of a multi-projector or multi-channel setup. By
having one projector project a red image and another project a green image, it is easier to spot and adjust the
overlap section.
By pressing this button multiple times, you will have different active filters, in the following cycle:
• Red + Green + Blue (default)
• Red only
• Green only
• Blue only
• Red + Green
• Green + Blue
• Red + Blue
• Red + Green + Blue
• etc
After powering up, the colors will always revert back to full RGB.
3.8 Pulse RCU, functions of the “Projector OSD on/
off” button
Functions Projector on/off button
While the light source is on, you can toggle on and off the projection of the On-screen display by pressing the
projector OSD on/off button.
From Pulse 2.3 onward, this button now supports another function. If “Stealth mode” has been configured for
the LCD display, pressing this button a long time (5 seconds or more) will activate or deactivate Stealth mode.
For more info on Stealth mode, see “Controlling the backlight of the LCD Display”, page 153.
3.9 Displaying and Programming addresses into
the RCU
Displaying the Projector Address on the Screen.
1. If the projector is on, press the menu key and navigate to the Status page. The projector address and the
broadcast address can be seen under the Communication heading.
The projector's address is displayed on the LCD status screen and / or the OSD.
How to Program an Address into the RCU?
1. Press the Address button until the Button pressed indicator lights up continuously (proximately 5
seconds).
2. Enter the address with the digit buttons within the time the indicator lights up (also proximately 5 seconds).
Note: That address can be any value between 0 and 31.
Pulse Remote Control Unit