R5911443 /11 UDM94
2. Confirm to reset the frame to its center position.
Note: Wait until the frame motors have stopped before doing other actions.
8.6 Configuring the lens, optical zoom and focus
About the Zoom focus menu
If no lens or a non-motorized lens is mounted on the projector, the zoom focus menu will not be available.
The Zoom-focus will only be visible if a motorized lens is mounted in the projector. When available, you can
use this menu to fine-tune the projected image.
Zoom - Focus
1. In the main menu, select Installation → Lens → Zoom focus.
Image 8–15 Lens menu, Zoom & Focus
The Zoom and focus menu is displayed.
Image 8–16 Example of the zoom and focus adjustment menu
2. Use the ▲ or ▼ key to zoom the lens in or out.
Use the ◄ or ► key to focus the lens to far or near.
8.7 Configuring the lens, shift
What can be done?
The image can be optically shifted by using the vertical and horizontal lens shift.
If you want to reach a lens shift beyond what is possible with the optical shift, you can also perform a digital
lens shift. This digital shift will occur on the DMD, rather than the lens holder. So take into account that this
additional shift is minimal and restricted to the limits of the chip used.
For the digital zoom and shift, navigate to Home → Image → Digital Zoom Shift. For more info, see “Digital
shift & zoom”, page 76.
GUI – Installation
To Next Page
Loading...
