Barco UDM - 3.12 Pulse RCU, silicone protection sleeve (optional)

R5911443 /11 UDM40
2
Image 3–9
Note: While the mini-jack cable is connected, the IR beam of the RCU is switched off.
3.12 Pulse RCU, silicone protection sleeve
(optional)
Introduction
Barco offers a silicone form fitting protection sleeve for the Pulse RCU. The silicone material keeps it
comfortably, non slip and soft touch. All buttons and openings remain accessible. The sleeve is quick and
easy installed. For ordering information see Barco website.
How to install
1. Pull off the rubber XLR-lid from the RCU.
Image 3–10
2. Place back side (XLR side) of the RCU into the sleeve and pull the other side of the sleeve over the front
side of the RCU.
Image 3–11
Pulse Remote Control Unit