Barco UDM - Page 85

85R5911443 /11 UDM
How to set the dynamic contrast?
1. In the main menu, select Image → Advanced → DynaBlack.
Image 7–41
The DynaBlack menu is displayed.
Image 7–42 Example of the DynaBlack menu
2. Select the desired dynamic contrast setting, or leave the default on (medium).
The result will slowly become visible.
Do not panic if there isn’t a visible change after a few seconds. Each change in the dynamic contrast
menu has an impact on the light source, thus these changes will only become visible over time.
GUI – Image