Barko Hydraulics 930 - Page 38

page 38page 38
page 38page 38
page 38
930/937 Mulcher (O)
800-00256
MURPHY POWER VIEW OPERATION CONTINUED...
ModbusModbus
ModbusModbus
Modbus®
SetupSetup
SetupSetup
Setup
1. From the UTILITIES menu, select MODBUS SETUP.
2. Select either the SLAVE ACTIVE (SCADA or remote Modbus master) or MASTER ACTIVE (auxiliary gages)
modes. Touch
Enter Enter
Enter Enter
Enter to toggle between master and slave.
3. Select SERIAL PORT SETUP (slave mode only), then touch
EnterEnter
EnterEnter
Enter.
4. Continue to scroll each selection (BAUD RATE, PARITY, DATA BITS, STOP BITS) to configure the serial port
parameters for your Modbus slave application.