Baroness LM331 - Description of Functions; Meter Panel Instruments - Lamps, Buzzer, Hour Meter

Thermo-start Lamp
The thermo-start lamp is the middle pilot
lamp, located in the meter panel.
When the ignition key is set to the "GLOW"
position, this lamp turns on while the glow
plug generates heat.
Illumination of the thermo-start lamp is
controlled by the glow lamp timer, and the
lamp is turned off after a specified amount of
time passes.
The duration of illumination indicates an
approximate period of time required for warm-
up, and has been fixed at five seconds.
1
q44uug-002
Thermo-start Lamp_001
1
Thermo-start lamp
Oil Pressure Lamp
The oil pressure lamp is the right pilot lamp,
located in the meter panel.
This lamp turns on when the ignition key is set
to the "ON" position before the engine starts.
It turns off when the engine starts and engine
oil pressure is generated properly.
If this lamp illuminates while you are operating
the machine, stop the engine immediately,
and then inspect the machine and perform
any necessary maintenance.
1
1ldikn-002
Oil Pressure Lamp_001
1
Oil pressure lamp
Overheat Warning Buzzer
If the water temperature inside the engine
exceeds 105 °C (221 °F), a buzzer will sound.
(intermittent tone)
Remove the load from the engine, idle the
machine for five minutes, stop the engine, and
then inspect the machine and perform any
necessary maintenance.
Hour Meter
The hour meter indicates the accumulated
operation time of the engine.
The number in red figures on a white
background is incremented every thirty-six
seconds.
The number in white figures on a black
background is incremented every hour.
1/100 wheel … red figures on a white
background
Hour wheel … white figures on a black
background
2
1
uknn6v-007
Hour Meter_001
1
1/100 wheel
2 Hour wheel
Description of Functions
LM331
Description of Functions
Page 4-7
Instruments in the Meter Panel