Baroness LM331 - Engine Oil and Fuel Inspection

The appropriate oil level should be between
the upper and lower limit lines on the
gauge.
23
1
rnr453-004
Inspection of Engine Oil_002
1
Oil level gauge
2 Upper limit
3 Lower limit
Supply of Engine Oil
Important
Do not supply too much engine oil. Otherwise,
the engine may be damaged.
Important
Do not mix different types of engine oil.
Important
Be sure to use engine oil that is classified as
API Service Grade CF or higher, with an SAE
Viscosity that is appropriate for the operating
environment (ambient temperature).
Important
Securely tighten the oil level gauge and oil
filler cap.
Engine oil is supplied through the oil filler
cap.
Remove the oil filler cap, and then supply
new engine oil until the oil reaches a level
in between the upper and lower limit lines
on the oil level gauge.
3.
1.
Securely install the oil filler cap.
1
gui678-019
Supply of Engine Oil_001
1
Oil filler cap
It will take a while for the supplied engine oil
to descend into the oil pan.
Check the oil level again 10 to 20 minutes
after supplying the oil.
Fuel
Inspection of Fuel Quantity
With the machine on a level surface, observe
the fuel gauge in the meter panel to check the
fuel level.
EF
1
4
FUEL
1
2
3
4
1
2e4emp-001
Inspection of Fuel Quantity_001
1
Fuel gauge
2.
3.
LM331
Handling Instructions
Page 5-12
Inspection and Cleaning