Direct dialling
Beacon call
"Hang-up call"
To access the direct dialling facility of the Barrett 660/960 telephone interconnect the
transceiver must be fitted with telcall.
- select the channel to be used to make the call (refer to Selcall (selective call
section - " ")
- listen for traffic on that channel, if no traffic then continue
- press the key
- enter the 660/960 destination ID using the numeric keys
- press the key
- enter the telephone number to dial using the numeric keys
- press the key
- when the telcall has finished sending listen for revertive tones that indicates the
call was successful.
- if the call was successful then wait for telephone connection to be made. When
the call has been answered, the user can talk as normal.
- after the call is complete or if the line is busy the user should hang up the line.
(refer to Selcall (selective call) section - )
BARRETT 950 HF TRANSCEIVER
PAGE 21
To Next Page
Loading...
