To un-lock a transceiver
Transceivers leaving the factory are set to the default code of 0000 0000 in this state the
transceiver lock feature will not operate.
If this is displayed the transceiver can only be unlocked using the Barrett PC based
programming software.
Note:- To save time entering codes ten times before unlocking - Enter 0000 0000 the
transceiver will immediately display "contact dealer"
On the transceiver receiving the lock out (disable) selcall the following will be displayed :-
You can now enter the pin number to unlock the transceiver.
If you input the wrong PIN number more than 10 times, the following is displayed :-
BARRETT 950 HF TRANSCEIVER
PAGE 70
To Next Page
Loading...
