Cloning and programming transceivers
Cloning
This feature in the 950 transceiver is used to copy the configuration of one 950 transceiver
to another using the serial interface on the rear 25 pin “D” connector or to receive
programming information from the Barrett PC based 900 series transceiver programming
system.
The following steps are necessary to copy the configuration of one 950 transceiver to
another :-
- Fit the “DB25" to “DB25" cloning cable, Barrett P/N BCA90024 to the auxiliary
connector on each transceiver.
- Switch on both transceivers.
Picture of two transceivers connected together with cloning lead
BARRETT 950 HF TRANSCEIVER
PAGE 62
To Next Page
Loading...
