Clarifier
The clarifier is used to compensate for received signals that are off frequency.
The receiver can be clarified in steps of 1Hz to frequencies from -1KHz and +1KHz of the
assigned channel frequency, depending on programming. To shift the clarifier use one of the
following keys
or
Pressing either of the above keys once will display the clarifier as follows
Release the key pressed then press it again to begin adjusting the clarifier. Holding the key
down will accelerate the clarifier rate of change until maximum rate of change is achieved or
the clarifier limit is reached. To clear the clarifier value, first bring up the clarifier then press
the key to zero the value.clear
BARRETT 950 HF TRANSCEIVER
PAGE 28
To Next Page
Loading...
