7 Connection /
commissioning (qualified
personnel)
Handscanners
BCS 3600
ex
series
50 / 72
Subject to technical modifications
17/05/18
7.3 BCS 3678
ex
-NI / BCS 3678
ex
-IS Bluetooth hand-held scanner
7.3.1 Connecting the cradle to the host PC and power source
DANGER
Spark formation when connecting a cable!
Explosion.
Only use the cradle outside the potentially explosive atmosphere.
‒ Power is supplied to the cradle either by means of the connection cable to the host PC if this
is conductive or using a separate power connection. Further information about the power
supply to the cradle can be found in the ZEBRA Product Reference Guide.
‒ If a separate power cable is used, this must always be disconnected from the power source
before disconnecting the data cable from the host PC or from the cradle. It is otherwise
possible that the cradle will be unable to establish any connection to a new host PC.
1. Connect the data cable to the host PC.
2. Open the cover, connect the data cable and close the cover.
To Next Page
Loading...
Need help?
General
