Bartec BCS 3608ex-NI - Restore Bluetooth Connection; Resetting the Hand-held Scanner

Handscanners
BCS 3600
ex
series
11 Faults – causes and
remedies
Subject to technical modifications
17/05/18
65 / 72
11.1 Restoring the connection between Bluetooth hand-held scanner and cradle
If the hand-held scanner is not transferring any data to the cradle, restore the connection as follows:
 All cables on the host and on the cradle are securely connected.
1. Unplug the mains cable from the cradle.
2. Unplug the connection cable from the cradle.
3. Wait 3 seconds.
4. Connect the connection cable to the cradle.
5. Connect the mains cable to the cradle.
6. Connect the hand-held scanner to the cradle.
11.2 Resetting the hand-held scanner
The hand-held scanner can be reset to default settings in two ways:
‒ Factory settings (see the ZEBRA Product Reference Guide, Annex A, Standard Default
Parameters)
‒ Customised default settings.
11.2.1 Resetting the hand-held scanner to default settings
The hand-held scanner is reset to the following default settings using the “Restore Defaults” barcode:
‒ If customised default settings have been configured: the hand-held scanner is reset to the
customised default settings
‒ If no customised default settings have been configured: the hand-held scanner is reset to factory
settings.

Scanning the “Restore Defaults” barcode.