8 Operation
Handscanners
BCS 3600
ex
series
56 / 72
Subject to technical modifications
17/05/18
8.1.4 Charging the battery
DANGER
Mixing up the batteries!
Loss of function and risk of explosion.
Only use batteries that have been specified by BARTEC.
Only the following batteries are approved:
Zone / Div. Battery type
Zone 1 / Div. 1 17-A1Z0-0012
Zone 2 / Div. 2 B7-A2Z0-0036
Tab. 28: Approved batteries
The model of battery is clearly indicated on the type label.
DANGER
Spark formation when charging the battery!
Explosion.
Only charge the battery outside the potentially explosive atmosphere.
Charging the battery with the cradle
The cradle is connected to a power source.
Place the hand-held scanner in the cradle to charge the battery (see Chapter 8.1.2, P. 54).
LEDs on the cradle flash yellow to indicate the start of the charging process.
LEDs on the cradle flash green to indicate the end of the charging process.
Charging the battery with 4-slot charging station for spare batteries
1. Point the contacts of the battery upwards.
Fig. 16: Sliding the battery into the 4-slot charging station
2. Slide the battery underneath the edge of the 4-slot charging station.
To Next Page
Loading...
Need help?
General
