Bartec BCS 3608ex-NI - Connecting the Bluetooth Hand-Held Scanner to the Cradle

Handscanners
BCS 3600
ex
series
8 Operation
Subject to technical modifications
17/05/18
55 / 72
8.1.3 Connecting the Bluetooth hand-held scanner to the cradle
The Bluetooth hand-held scanner sends data to the cradle. The cradle sends these data to a host
PC. To exchange data, the cradle must be connected to the hand-held scanner.

To connect the hand-held scanner to the cradle, place the hand-held scanner in the cradle (see
Chapter 8.1.2, P. 54)
– or –
Scan the connection code on the cradle.
If the display is illuminated in red, the transfer has failed.
If the status LEDs are lit up in green, the hand-held scanner is connected to the cradle.