Barudan BENS - Page 102

Power Failure ...........3-10
Powering Off ............1-18
Powering On ............1-17
Production Statistics ........2-19
Program ..............2-15
Program parameters .....2-15,2-17
A Offset ............2-16
Angle .............2-16
Appliqué ............2-16
CAP Frame ...........2-17
F. Offset ............2-17
Frame .............2-17
Frame Type ..........2-17
H Scale ............2-15
Origin .............2-16
Repeat .............2-17
ROT Pattern ..........2-15
Socks..............2-16
V Scale.............2-15
Programming the Pattern ......1-9
Protecting Patterns .........1-10
R
Read ................1-14
Read Softkey ............1-14
Reading from floppy disks ......2-2
Reading from tape ..........2-3
Reading Patterns...........2-2
Reading patterns from COM port . . 2-5
Rename ..............2-13
Renaming a pattern ........2-13
Repairing Missed Stitches .....1-10
Automend
Stitchback 1-10
Repairing stitches .........3-23
Resume ..............3-10
Resume, after power off ......1-10
ROT pattern ............2-15
RS-232C cable ...........1-24
S
Safety ...............1-23
Danger .............1-3
Perimeter Trace . . . . . ....1-9
Safety Instructions ........1-5
Warning .............1-3
Saving Patterns. . . ......1-9,2-27
Saving patterns to floppy disk . . . 2-27
Saving patterns to peripheral devices2-28
Saving patterns using COM . . . . 2-29
Setting up a password .......2-30
Sewing .........1-2,3-1,3-6,3-8
Sewing Controls ...........3-2
Sewing from Memory ........3-8
Sewing Speed . . . . . . . . . . . 1-10
Sewing Speed Control ........3-3
Sewing speed recommendations . . 3-3
Sewing speed, changing . . . . . . . 3-3
Soft Limits ..............1-9
Softkeys . . . . ..........1-14
Software Updates . . . . . . . . . 1-20
Specifications . . . . . . . . . . . 1-24
Speed ...............1-14
Speed Softkey . . . . . . . . . . . 1-14
Standby
Using Standby . . . . . . . . . 3-10
Start/Stop Bars or Buttons ......3-6
Stitchback . .........1-10,3-23
Sub Soft Limits . . . . . . . . . . . 1-10
T
Tajima disk format..........2-2
Tape connection...........2-4
Tape formats.............2-3
Teach . ............1-14,3-17
Display Method . . . . . 3-17,3-19
Sewing Method. . . . . . 3-18,3-20
Teach Softkey . . . . . . . . . . . 1-14
Temperatures ............1-8
Temporary Repair Stops . . . . . . 3-25
iv BENS Operation Guide - 12/99