9424200996 80-13
BE1-11m Specifications
Panel Display
64 by 128 dot pixels LCD with LED backlight.
Operating Temperature ............................................. –40 to 158°F (–40 to 70°C). Display contrast
adjustment may be impaired below −4°F (−20°C).
Temperature
Operating Temperature Range ................................. –40 to 158°F (–40 to 70°C)*
Storage Temperature Range .................................... –40 to 158°F (–40 to 70°C)
* Display is inoperative below −4°F (−20°C)
Isolation
Meets IEC 255-5 and exceeds IEEE C37.90 one minute dielectric test as follows:
All Circuits to Ground* .............................................. 2,000 Vac or 2,828 Vdc
Input Circuits to Output Circuits ................................ 2,000 Vac or 2,828 Vdc
Communication Ports to Ground ............................... 700 Vdc for one minute
* Excludes communication ports.
Standards
IEC Standards:
• IEC 60068-1 – Environmental Testing Part 1: General and Guidance. Temperature Test
• IEC 60068-2-1 – Basic Environmental Testing Procedures, Part 2: Tests - Test Ad: Cold (Type
Test)
• IEC 60068-2-2 – Basic Environmental Testing Procedures, Part 2: Tests - Test Bd: Dry Heat
(Type Test)
• IEC 60068-2-28 – Environmental Testing Part 2: Testing-Guidance for Damp Heat Tests
• IEC 60255-4 – Single Input Energizing Quantity Measuring Relays with Dependent Specified
Time
• IEC 60255-5 – Electrical Insulation Tests for Electrical Relays. Dielectric Test and Impulse Test
• IEC 60255-6 – Electrical Relays - Measuring Relays and Protection Equipment
• IEC 60255-21-1 – Vibration, Shock, Bump, and Seismic Tests on Measuring Relays and
Protective Equipment (Section 1 - Vibration Test - Sinusoidal). Class 1
• IEC 60255-21-2 – Vibration, Shock, Bump, and Seismic Tests on Measuring Relays and
Protective Equipment (Section 2 - Shock and Bump Test - Sinusoidal). Class 1
IEEE Standards:
• IEEE Std C37.90.1-2002 – IEEE Standard Surge Withstand Capability (SWC) Tests for Relays
and Relay Systems Associated with Electric Power Apparatus
• IEEE Std C37.90.2-2004 – IEEE Standard Withstand Capability of Relay Systems to Radiated
Electromagnetic Interference from Transceivers
• IEEE Std C37.90.3-2001 – IEEE Standard Electrostatic Discharge Test for Protective Relays
CE Compliance
This product has been evaluated and complies with the relevant essential requirements set forth by the
EU legislation.
EC Directives:
• LVD 2014/35/EU
• EMC 2014/30/EU
• RoHS 2 2011/65/EU
To Next Page
Loading...
Need help?
General
