Baumuller BM5-O-SAF-000 - Working Principle Parameter Module (BM5-O-SAF-000-000-000)

Working principle parameter module (BM5-O-SAF-000-000-000)
Operation Manual Safety Module for b maXX 5000 BM5-O-SAF-000/-001
Document no.: 5.09013.07 Baumüller Nürnberg GmbH
32
of 114
7.3
7.3 Working principle parameter module (BM5-O-SAF-000-000-000)
The adjusted parameters of the b maXX 5000 axis unit can be stored on the SAF-000 pa-
rameter module. The parameter backup is carried out by the parameterization software
Pr
oDrive. The software provides this function with adequate buttons at the page „Data set
management“. By selecting these buttons parameter data can be written to or read from
the SAF-000.
Figure 1: Data set management ProDrive
NOTICE!
The parameter data cannot be copied to the SAF-000 Parameter module, if a com-
plete data set which was loaded before of that from the RAM with all th
e parameters, 
was loaded in the flash memory of the b maXX 5000 again.