Baumuller BM5-O-SAF-000 - Requirements on the Personnel Conducting the Work

DANGER!
Danger of injury due to moving parts!
Machine parts/line parts or the entire machine/line can move during commissioning.
Th
e „Planning checklist“ reproduced in the appendix ZCommis
sioning and validation
checklist– fr
om page 102 is to be used in the commissioning phase.
Therefore:
m M
aintain an adequate distance from moving machine parts/line parts or from the
moving machine/line.
m Note
that the machine parts/line parts or machine/line can be set in motion via
additional modules connected to the Safety Module.
m Ac
tivate the safety devices in any case prior to switching on the system.
m Make
sure that the system is commissioned exclusively by qualified personnel.
m M
ake sure that there are no people in the danger zone during the initial
commissioning. Always anticipate that a machine, system or safety device may not
behave as it is intended to.
m If ch
anges or expansions are conducted during the commissioning process, the
effects on the behavior of the system will have to be inspected. To do this, it will be
necessary to process the checklists for the planning and installation phase again.
Requirements on the personnel conducting the work
Operation Manual Safety Module for b maXX 5000 BM5-O-SAF-000/-001
Document no.: 5.09013.07 Baumüller Nürnberg GmbH
78
of 114
13.2
13.2 Requirements on the personnel conducting the work
The commissioning work may only be conducted by professionally trained personnel, in
particular personnel which understands the safety regulations and can follow them.
DANGER!
Danger from mechanical action!
The machine/line or parts of the machine or line can be started during the
co
mmissioning of the Safety Module.
Therefore:
m M
aintain an adequate distance from moving machine parts/line parts or from the
moving machine/line.