To Next PageTo Next PageWhat to do if Baumuller b maXX BM4-O-CAN-03 Control Unit m is blinking four times then pause?
If the Baumuller Control Unit m is blinking four times and then pausing, it indicates a hardware error with the device b maXX 4400. The suggested solution is to send the device b maXX 4400 to Baumüller Nürnberg GmbH.
General| Brand | Baumuller |
|---|---|
| Model | b maXX BM4-O-CAN-03 |
| Category | Control Unit |
| Language | English |
Initial steps after receiving the module, including delivery check and personnel assignment.
Safety regulations for the plant where the appliance is installed.
Explains dangers leading to injury or death and general safety precautions.
Guidelines for using the appliance within its specifications and intended applications.
Defines qualified personnel and requirements for assembly, installation, and operation.
Describes the physical structure of the CANopen slave module and its connectors.
Details how to set baud rate and Node-ID using DIP switches on the module.
Step-by-step guide for physically installing the plug-in module into the controller unit.
Illustrates the pin assignment for the CANopen connection on the module.
Detailed explanation of LED behavior during switch-on, initialization, and commissioning for PLC.
Outlines the steps for recognizing and testing the CANopen slave module.
Describes error messages displayed via LEDs and corresponding reactions.
Troubleshooting steps when the module fails to establish CANopen network communication.
Lists the technical specifications of the BM4-O-CAN-03 option module.
Details the pin configuration for the RJ45 connectors on the module.
Provides a visual guide and explanation for the DIP switch settings.
