Baumuller b maXX BM4-O-CAN-03 - Continue Communication for B Maxx PLC; Error - no Communication B Maxx PLC

Error detection and trouble shooting
Instruction handbook CANopen slave BM4-O-CAN-03
Document no. 5.02014.06
43
of 68
8
8.3.1.3 Continue communication for b maXX PLC
If the communication with the CANopen network is established, the option module CANopen
slave tries to continue the communication with the CANopen network. If the communication
cancels, the red LED H2 flashes up:
Figure 13: Error - no communication b maXX PLC
Further information is to be found in ZD.4 LEDs– from page 64.
NOTE
Further details are to be found in the „Operation manual b maXX 4400“, and in the „Applica-
tion handbook CANopen slave for b maXX PLC“.