Baxi Power HT Series User Manual

96
910.001.1 - EN
ISTRUCTIONS PERTAINING TO THE INSTALLER
c) with AGU2.500 for control of a low temperature system:
RefertotheinstructionsprovidedwiththeAGU2.500accessoriesforconnectionandcontrolofalowtem-
perature zone.
In this case some electronic parameters must be modied (see §14) (H552-H553-H632).
The electrical connection and settings needed to control a system divided into zones vary depending on the
accessories connected to the boiler.
a) Without QAA73 room temperature control device:
The contact relating to the request for operation of the various zones must be parallel-connected and connected
to terminal 3-4 “TA” of terminal block M2 in gure 10. The jumper present must be removed.
The central heating temperature is selected directly on the boiler control panel in accordance with the instruc-
tions provided for the user in this manual.
b) with QAA73 room temperature control device:
The pump relating to the room controlled by the QAA73 temperature control device must be supplied with
electricity by means of terminals 11-12 of terminal block M3 in gure 10.
The contact relating to the request for operation of the other zones must be parallel-connected and connected
to terminal 3-4 “TA” of terminal block M2 in gure 10. The jumper present must be removed.
The central heating temperature of the zone controlled by the QAA73 is set automatically by the QAA73 itself.
The central heating temperature of the other zones must be selected directly on the boiler control panel.
In this case some electronic parameters must be modied:
H552 = 50, H632 = 00001111.
c) with AGU2.500 for control of a low temperature system:
RefertotheinstructionsprovidedwiththeAGU2.500accessoriesforconnectionandcontrolofalowtem-
perature zone.
In this case some electronic parameters must be modied (see §14) (H552-H553-H632).
12.6 CONNECTING A ZONE SYSTEM
Figure 10
0702_0501 /
CT_0675
1 ZONE
(QAA73)
n ZONE
(ROOM THERMOSTAT)
3 ZONE
(ROOM THERMOSTAT)
2 ZONE
(ROOM THERMOSTAT)
1 ZONE PUMP
BOILER
CIRCULATING
PUMP
BOILER
PUMP
HEATINGCUT-OUT
RELAY
2 ZONE-
PUMP
3 ZONE-
PUMP
N ZONE-
PUMP

Baxi Power HT Series Specifications

General

Model	Power HT Series
Type	Condensing Boiler
Installation	Wall-mounted
Heat Exchanger Material	Stainless Steel
Fuel Type	Natural Gas / LPG
Modulation Ratio	1:10
Ignition Type	Electronic
Safety Features	Flame Failure Protection
NOx Emissions	Low NOx