Sign of trouble Cause of trouble Actions to eliminate the trouble
No sound
1.Poor audio cable connection
2.Disc dirty or damaged.
3.Sound disabled by the MUTE button.
1.Make proper connection.
2.Clean the disc.
3. Press the MUTE button.
No image
1.Poor video cable connection.
2.Incorrect settings of your TV set.
3.The DVD receiver's is in the progressive
scan mode while your TV set does not
support this mode.
1.Make proper connection.
2.Correct the settings of your TV set.
3.Place the DVD receiver in the interlaced
scan mode through the DVD-receiver's
menu.
Black and white image
1.Incorrect TV color system selected.
2.Color level on the TV set adjusted
incorrectly.
1.Set the approprlate color system vla the
menu: SETUP＞Image＞TV scan.
2.Readjust the color system of your TV
set.
Discs cannot be read
1.Disc not inserted.
2.Disc inserted incorrectly.
3. Condensate on the DVD receiver's
laser head.
1. Insert the disc.
2.Install the disc with the label side facing
up.
3. Switch the DVD receiver on without
disc for and hour.
Microphone does not
operate
1.Microphone is unplugged.
2. Low level of the microphone's sound
volume.
1. Connect the microphone.
2. Adjust the level of the microphone's
sound volume.
Remote control does
not operate
1.Remote control is incorrectly directed at
the DVD players's screen.
2.Distance to the DVD receiver is in
excess of 8 meters.
3. Run out batteries.
1.Use the remote control according to the
manual.
2. Decrease the distance to the DVD
receiver.
3. Replace both batteries.
Some functions do not
work
1. Disc is recorded incorrectly.
2.Incorrect key sequence.
3.Static voltage on the DVD receiver's
housing.
1.Wait 5-10 seconds and the DVD
receiver will automatically return to normal
state.
2. Repeat the operation one more time.
3.Switch the DVD receiver off for 1-2
minutes and then switch it on again.
Unstable image 1.Incorrect TV set settings. 1.Correct the TV set settings.
-14-
To Next Page
Loading...
