Page 11
Now set up a microphone to pick up the instrument, and run an XLR cable from the microphone to
an input channel under the stage plate – note the channel number and musician on the worksheet.
OPTIONAL VOCALS: Run an XLR cable from the microphone to INPUT 2 on the FX150, and then run an
XLR cable from the THRU connection into an input channel under the stage plate – note the channel
number and musician on the worksheet.
Make sure the monitor is OFF, check the settings on the back panel and reset the monitor to defaults
– See Section 9.1.
The musician is now configured with optional vocals. See the section on using the FX150 monitor
and remind the musician how to use the monitor.
In this configuration:
INPUT 1 on the FX150 controls the monitor level
INPUT 2 on the FX150 controls the voice level (OPTIONAL)
The MASTER knob controls the overall level of the monitor
Figure 12 - Monitor Setup for Acoustic Instrument
To Next Page
Loading...
