Page 23
4.3 STAGE MONITOR CONFIGURATION
So up to this point we have configured the board, set up all of the channels, and we are ready to
configure the stage monitors.
To view the Stage Monitor send, press the Bus 1-8 Button (labelled Monitor/FX) and you will see the
first slot identified as MONITOR.
Figure 29 - Monitor Bus Selected
The fader controls the overall volume to the stage monitors – all stage monitors 1-7 are controlled
from this one fader. Individual volume control, or “more me” mix control (if configured that way) is
done on the Stage Monitors themselves so remind your musicians about that when they ask you to
turn things up. If you turn up the monitor fader, it turns up ALL monitors.
To Next Page
Loading...
